Purchase Here Online

PricePanelHeader();
PricePanelLoad(‘1w1a12s’);

Do You Have Any Questions? Please Message Us Here …

WebMail();

What’s in the Box

This neat package, which INCLUDES our 1W CE Marked (EU Standard) stereo transmitter, and one tuned dipole antenna with 12 metres of cable. This combination gives exactly 1W ERP from the dipole antenna, The package was originally designed for use for low power broadcasting in New Zealand. However it is suitable for any low power broadcasters wishing to cover a small complex such as a university complex, hospital grounds, very small village, theme parks etc.

Operation

Any frequency between 87.5 to 108MHz can be accurately programmed on the internal dip switches accessible from the underside panel in a few minutes. Expensive test equipment is NOT required, set up is a simple task using the LED’s on the front panel. The transmitter operates from a 13.8V DC supply or the supplied AC adapter (100 – 250VAC). This makes it suitable for use on a standard power pack or automobile power system anywhere around the world.

5 Year Warranty

On delivery the equipment is ready to plug in and use. This transmitter is so reliable we can give it a 5 year warranty and our reputation of high reliability without any hesitation.

Compliance

When used with suitable audio limiting equipment, this complete set of equipment used as delivered without any modifications, including it’s power supply, the dipole antenna and the 12 metres of antenna cable, complies with New Zealand Radio Communications Regulations (General User Licence for Low Power FM Broadcasting) Notice 2010 Schedule 1 Transmitter Emission Requirements. It also complies with EU Telecommunications ETS 300384, EMC EN 301 489-11 and Safety LVD 2006/95/ and also ITU-R BS.450-3 (11/01) FM Broadcasting at VHF. If you are a novice or beginner and you don’t have any knowledge of audio limiting, processing and compression you will need to purchase an additional audio limiter at http://www.aareff.com/en/fm-transmitter-limiter/ version ALSB to maintain compliance with the regulations.

Technical Specification

15VDC or 90-260 VAC 48-62 Hz
Freq Adj. Accuracy+/- 50 Hz

RF Output 1000mW ERP +/- 0.5 dB
Deviation Sensitivity Stability +/-2% max

0dB Gain using Dipole with 12m RG58 Cable
Audio In Phono/RCA type unbalanced sockets

RF Output Connector BNC
Pre-emph (50uS/ 75uS/ None) Selectable

RF Harmonics >75dB rtc
Audio Level 0.775 V rms for +/- 75 KHz

RF Spurious >63dB rtc
Signal to Noise Ratio 80 dBu

Out of Lock Suppression >63dB rtc
Audio Freq Stereo +/- 0.5dB 30Hz to 15 KHz

Freq 100KHz steps from 87.5 to 108MHz
Audio Distortion Better than 0.02 % THD

Stability Extreme +/- 2 KHz from -20 to +40 Deg C
Stereo Crosstalk better than 35dB

Stability Normal +/- 300 Hz at 20 Deg C
Stereo Pilot Tone 19KHz

Fine Freq. Adj.> +/- 1000Hz
Pilot Tone Stability 0.2Hz